Filter
Top Products
E-17
Optimizing RGB Picture Automatically
Adjusting the Image Using Auto Adjust
Optimizing RGB image automatically
Press the AUTO ADJ. button on the projector cabinet to optimize an
RGB image automatically.
[Poor picture]
[Normal picture]
Press the AUTO ADJ. button on the projector cabinet to fine-tune the
computer image or to remove any vertical banding that might appear
and to reduce video noise, dot interference or cross talk (this is evident
when part of your image appears to be shimmering). This function ad-
justs the clock frequencies that eliminate the horizontal banding in the
image. This function also adjusts the clock phase to reduce video noise,
dot interference or cross talk. (This is evident when part of your image
appears to be shimmering.)
This adjustment may be necessary when you connect your computer
for the first time.
NOTE:
• Some signals may not be displayed correctly or take time.
• The Auto Adjust function does not work for component and video signal.
• If the Auto Adjust operation cannot optimize the RGB signal, try to adjust Clock
and Phase manually. See page E-24.
Turning Up or Down Volume
Sound level from the speaker on the projector can be adjusted.
NOTE: When the menu appears, you cannot adjust the volume.
increase volume
Turning off the Projector
To turn off the projector:
First, press the POWER (ON/STAND BY) button on the projector cabi-
net or the remote control. The “Power Off / Are you sure?” message will
appear.
Secondly, press the ENTER button or press the POWER (ON/STAND
BY) button again.
The power indicator will glow orange. After the projector turns off, the
cooling fans keep operating for 60 seconds (Cooling-off time).
Lastly, turn off the Main Power switch. The power indicator will go out.
Last unplug the power cable.
decrease volume
CAUTION
Do not unplug the power cable from the wall outlet or do not turn
off the main power under any one of the following circumstances.
Doing so can cause damage to the projector:
• While the Hour Glass icon appears.
• While the cooling fans are running. (The cooling fans continue
to work for 60 seconds after the projector is turned off).
Turning off the Image and Sound
Press the MUTE button on the remote control to turn off the image and
sound for a short period of time. Press again to restore the image and
sound.