Filter
Top Products
Xen IPK Xen IPK Programming
IPK IAD Megaco Extension Quick Setup Guide 35
Doc. No. 8684 - Release 1.0
June 2004
S
ECTION
2
XEN IPK
P
ROGRAMMING
After the Dip Switches have been set and the IAD ETU has been installed in
the Xen IPK KSU, you are ready to program the settings the for the IAD
ETU.
The IAD (8)-U( ) ETU (MEGACO Station) is recognised by the Xen IPK
system as a ESI(8)-U( ) ETU. This ETU takes a longer time to initialize than
the other Xen IPK ETUs and must be programmed using Memory Block 7-1
(Card Interface Slot Assignment).
2.1 Programming the ETU Interface Slot
The following procedure provides the general directions for Xen
IPK programming for the ETU Interface Slot Assignment.
1. From port 01 or 02, enter programming mode.
2. Press
T U LKL.
3. Assign the Card Interface Slot Assignment by pressing LK7 and LK1.
4. Press
A, B or Cfor the cabinet number of KSU where the IAD
(8)-U( ) ETU is installed.
5. Press
Lto move the cursor to the right.
6. Enter slot number (1~8) of the KSU containing the IAD (8)-U( ) ETU.
7. Press
S to change the page number (Page 2) and assign the ESI
ETU. Press LK1.
8. Press
N to write the data.
9. Additional programming is required to assign telephone type and
station number.
10. Assign the telephone type assignment by pressing LK7 and LK2.
If assigning MEGACO terminals, assign ports as TEL=LK2.
11. Assign station number assignment on a per port basis (MB 4-10).