Filter
Top Products
10/100 Port Aggregator Tap
9
Connecting to the Monitoring Device(s)
1. Supply power to the Tap using the power supplies included with the unit.
Two power supplies are included. The use of the second redundant power
supply is optional.
Note: ________________________________________________________________
The second power supply is available to support the ow of trafc to the moni-
toring device, in the event that the rst power supply becomes unavailable. If
the rst power supply is unavailable, the second power supply will supply all
power for the Tap. Even if no power is available to the passive Tap, network
trafc ows uninterrupted.
______________________________________________________________________
2. Verify that the Power LEDs illuminate. PWR 1 illuminates when the rst
power supply is in use, and PWR 2 illuminates when the second power
supply is in use. Both power supplies can be plugged into the Tap at the
same time.
3. Connect Monitoring Port 1 to the appropriate port on the monitoring
device using a CAT5 RJ45 straight-through cable to monitor the full-
duplex link.
4. If you are installing model PAD-CU-AR, connect Monitoring Port 2 to the
appropriate port on the monitoring device using a CAT5 RJ45 straight-
through cable to monitor the full-duplex link.
22B 11A
10
100
LINK
ACT
10
100
LINK
ACT
10
100
LINK
ACT
10
100
LINK
ACT
®
1
2
www.netoptics.com
22B 11A
Passive Dual
Port Aggregator with
Active Response
Passive Dual
Port Aggregator with
Active Response
10
100
LINK
ACT
10
100
LINK
ACT
10
100
LINK
ACT
10
100
LINK
ACT
®
1
2
www.netoptics.com
To monitoring device 1
To monitoring device 2 (96448)
Figure 8: Connecting to Monitoring Device(s)