Filter
Top Products
NP642 IEEE 802.11g PCI Adapter 11
YML785 Rev1
Connecting the Antenna
Before continuing with the Software Installation section, you will need to connect the
antenna
1. The antenna has a retaining nut which must be screwed into the connector on the back
of the card. Place the screw retaining nut over the antenna connection on the rear of
the NB642 and turn it clockwise.
Note: Do not over-tighten the attaching nut - but do make sure that
you have screwed it all the way to its end.
2. Adjust the antenna to a 90
o
angle.
Note: Please note that you may have to rotate the complete antenna
assembly to do this and have the antenna pointing vertically.
Screw
retaining nut
clockwise
over the
antenna
connection
Bend
antenna
to a 90
o
angle