Filter
Top Products
NS370 / NS370W User Guide 9
YML814 Rev1
Rear Panel
1. Network Cable Connector
The Internet Camera’s rear panel features an RJ-45 connector for connections to 10Base-
T Ethernet cabling or 100Base-TX Fast Ethernet cabling (which should be Category 5
twisted-pair cable). The port supports the N-Way protocol and “Auto-MDIX” function,
allowing the Internet Camera to automatically detect or negotiate the transmission speed
of the network.
2. External Antenna (for NS370W only)
The rotatable external antenna allows you to adjust its position to obtain the maximum
signal.
3. Reset Button
Reset will be initiated when the reset button is pressed once, and Power LED begins to
flash.
Factory Reset will be initiated when the reset button is pressed continuously for three
seconds or when Power LED begins to light up. Release the reset button and the Power
LED will begin to flash, indicating the Internet Camera is changing to factory reset.
When factory reset is completed, the Internet Camera will be set to default on channel
11 and SSID is set as “NULL String” (This default setting will let the Internet Camera
connect to ANY access point on the infrastructure network). The IP address will also
return to the default setting as 192.168.0.20.
4. DC Power Connector
The DC power input connector is located on the Internet Camera’s rear panel, and is
labelled DC5V with a single jack socket to supply power to the Internet Camera. Power
will be generated when the power supply is connected to a wall outlet.
Top/Bottom Panel
Screw Hole
Located on the top/bottom panel of the camera, the screw hole is used to connect the camera
stand onto the camera by attaching the screw head on the camera stand into the screw hole
of the camera.