Filter
Top Products
Model FA510 Network Card Installation Guide
This guide provides you with instructions for installing the Windows Network
Driver. The steps given in these instructions are for users of Windows 98.
If you are using Windows 95, read these instructions thoroughly for an overview
of the steps that are necessary for the installation of the software driver. If you
are installing network cards and drivers on more than one computer operating
with Windows 95, you might find that all versions of Windows 95 do not
respond with the same screens, and windows might open in a different order.
Before you proceed with the installation steps, decide on a name for your
network and for each PC (each name must be only one word). You also need to
have the Windows CD-ROM and the FA510 Drivers and Diagnostics Disk ready
to use in the installation process.
1. Turn on the power to the computer and start Windows 98.
The new hardware is found.
2.
Click on “Next.”
Note: You must install the network card (instructions on other side of
this guide) before installing the network driver.
Note: If the “Insert Disk” window opens and the “Please insert the disk
labeled Windows 98...” message appears at any time during the
following process, insert the Windows 98 CD-ROM in Drive D (the
CD-ROM drive) and click on “OK.” Then follow the next step in the
instructions.
Install the Network Driver
< Back Next> Cancel
Add New Hardware Wizard
This wizard searches for new drivers for:
A device driver is a software program that
makes a hardware device work.
PCI Ethernet Controller