NETGEAR M4100-26G-POE Switch User Manual


 
Management Commands
651
ProSafe M4100 and M7100 Managed Switches
no username snmpv3 encryption
Use this command to set the encryption protocol to none. The <username> is the login user
name for which the specified encryption protocol will be used.
Format no username snmpv3 encryption <username>
Mode
show users
Use this command to display the configured user names and their settings. This command is
only available for users with Read/Write privileges. The SNMPv3 fields will only be displayed
if SNMP is available on the system.
Format show users
Mode
User Name
Access Mode
SNMPv3
Access Mode
SNMPv3
Authentication
SNMPv3
Encryption
show users accounts
Use this command to display the local user status about user account lockout and password
aging.
Format show users accounts
Mode
Global Config
Privileged EXEC
Term Definition
The name the user enters to login using the serial port, Telnet, or web.
Shows whether the user is able to change parameters on the switch (Read/Write) or is
only able to view them (Read Only).
As a factory default, the “admin” user has
Read/Write access and the “guest” has Read Only access. There can only be one
Read/Write user and up to five Read Only users.
The SNMPv3 Access Mode. If the value is set to ReadWrite, the SNMPv3 user is able
to set and retrieve parameters on the system. If the value is set to ReadOnly, the
SNMPv3 user is only able to retrieve parameter information.
The SNMPv3 access mode
might be different than the CLI and Web access mode.
The authentication protocol to be used for the specified login user.
The encryption protocol to be used for the specified login user.
Privileged EXEC
Term Definition
User Name
The local user account’s user name.
Privilege
The user’s privilege level (1-15).
Password aging
The password aging time for the local users.