Filter
Top Products
ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)
Management 3-3
v2.0, September 2006
2. Enable SysLog – Enable this option if you have a SysLog server on your LAN. If enabled,
you must enter the IP address of your SysLog server and the port number your SysLog server
is configured to use.
a. SysLog Server IP address –The access point will send all the SysLog to the specified IP
address if SysLog option is enabled. Default: 0.0.0.0
b. Port – The port number configured in the SysLog server on your LAN. Default: 514
3. Click Apply to save your Syslog settings.
The Activity Log Window displays the Access Point system activity.
Click Refresh to update the display or click Save As to save the log contents into a file on your PC
or to save the file to a disk drive.
Viewing General Summary Information
The General information screen provides a summary of the current WAG102 configuration
settings, including current IP settings and current Wireless settings. This information is read only,
so any changes must be made on other screens.
To access the General screen:
From the main menu of your browser interface, select General to view the General system status
screen, shown in Figure 3-3 below. This screen shows the following parameters:
Table 3-1. General Information Fields
Field Description
Access Point Information
Access Point Name
(NetBIOS name)
The default name may be changed if desired.
MAC Address Displays the Media Access Control address (MAC address) of the wireless
access point’s Ethernet port.
Country/Region Displays the domain or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access point in
a region other than one of those identified in this field.
Firmware Version The version of the firmware currently installed.