NETGEAR WG102 Network Router User Manual


 
Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point
2-6 Introduction
October 2004
Hardware Description
The NETGEAR WG102 ProSafe 802.11g Wireless Access Point front and rear hardware functions
are described below.
The WG102 Access Point provides four status LEDs.
Figure 2-1: WG102 front panel
The following table explains the LED indicators:
LED DESCRIPTION
PWR Power Indicator
Off No power. If this LED does not come on with the power adapter and cord correctly
installed, see Chapter 4, Troubleshooting.
On Power is on.
TEST Self Test Indicator
Blink Indicates self test, loading software, or system fault (if continues).
Note: This LED may blink for a minute before going off.
LAN Ethernet link indicator
Off No connection detected on the Ethernet link
Amber On Indicates 10 Mbps Ethernet link detected
Amber Flashing Data is being transmitted or received on the 10 Mbps Ethernet link
Green On 100 Mbps Fast Ethernet link detected.
Green Flashing Data is being transmitted or received on the 100 Mbps Ethernet link
WLAN Wireless LAN Link Activity Indicator
Off Indicates no wireless link activity.
Green Blink Wireless link activity.
NEED PRODUCT PHOTO
OR ILLUSTRATION