Filter
Top Products
Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point
Management 4-3
October 2004
Table 4-1. General Information Fields
Field Description
Access Point Information
Access Point Name
(NetBIOS name)
The default name may be changed if desired.
MAC Address Displays the Media Access Control address (MAC address) of the
wireless access point’s Ethernet port.
Country/Region
Displays the domain or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access
point in a region other than one of those identified in this field.
Firmware Version
The version of the firmware currently installed.
Access Point Mode Identifies the operating mode of the WG102: Access Point,
Point-to-point bridge, Multi-point bridge or Repeater.
Current IP Settings
IP Address The IP address of the wireless access point.
Subnet Mask
The subnet mask for the wireless access point.
Default Gateway
The default gateway for the wireless access point communication.
DHCP Client Enabled indicates that the current IP address was obtained from a
DHCP server on your network. Disabled indicates a static IP
configuration.
Current Wireless Settings
Operating Mode
Identifies the 802.11 operating mode of the WG102.
Wireless Network Name (SSID) Displays the wireless network name (SSID) being used by the
wireless port of the wireless access point. The default is NETGEAR.
Channel/Frequency Identifies the channel the wireless port is using. 11 is the default
channel setting. See “Wireless Channels” on page B-7 for the
frequencies used on each channel.
WEP/WPA WEP/WPA setting.