Filter
Top Products
ASI-IP-GTW User's Manual
Page 23
Table 7. Optional SFP Ethernet data port
Note: Please note that the optional SFP slot always provide Gigabit
Ethernet. Other bitrates are not supported by the SFP slot.
Note: Please note that data will not be available simultaneously on the
electrical Ethernet port and the SFP slot. Through the user interface
the user selects on which port the data should be available.
2.4.4 Ethernet management port
The ASI-IP-GTW is provided with an Ethernet management port for
configuration and control. The interface is 100Base-T. Please connect
the management port to the appropriate LAN for configuration and
control.
Table 8. Ethernet management port
Two LEDs are associated with the Ethernet management port.
2.5 LEDs
The ASI-IP-GTW is equipped with 4 LEDs at the front. The following
table describes the meaning of the front LEDs.
Table 9. Front panel LEDs
The front LEDs are replicated at the rear panel.
Each ASI port has two LEDs associated with it.
Item Specification
Type Gigabit Ethernet, Small Form-Factor Pluggable
(SFP) slot to carry copper or optical SFP,
compatible with approved modules conforming to
the Small Form-factor Pluggable Transceiver
MultiSource agreements (Sept.14, 2000).
Optical interface must comply with safety
requirements IEC 60825 (Class 1) and 21 CFR
1040.10 & 1040.11 (Class 1).
Item Specification
Safety status SELV
Type 10/100Base-T
Connector type RJ45
Indicator Colour Description
Power Green This LED is lit when power is being received by the
unit.
Alarm Red This LED is lit when a failure is detected by the unit.
IP TX Blue This LED is lit when the unit is configured to transmit
data to the IP Network.
IP RX Yellow This LED is lit when the unit is configured to receive
data from the IP Network