Filter
Top Products
IP POWER 9212 USER MANUAL
4. Hardware & Software installation
Before you star to use IP Power 9212, please follow the steps below:
Check the package to make sure the contents is complete.
Prepare one Ethernet HUB, or Router
Check the voltage of the power supply to make sure it is AC 110-240 volt
Hardware Installation : Connect RJ45 first then POWER jack
1 Connect the 9200 to HUB through RJ 45 netting cable.
2 Connect the 9200 (IN) to 9201 & 9200 ( OUT ) to 9202 through D-SUB cable.
Please connect 9200 D-SUB IN to 9200 IN port
& 9200 D-SUB OUT to 9202 OUT port
3 Connect the HUB to the Internet (May through ADSL/XDSL modem).
4 Connect the power adapter to the 9200.
Power on your computer and power adapter of IP POWER 9212.
9201Pro Hardware connection (recommend):
For different request of normal state of electric equipment, 9201 offers four sets of voltage signal
IN1-IN4 and four sets of shortcut circuit signals IN5-IN8.
9201 Pro provide 4set Source mode - Voltage Input – Out 1 ~ Out 4
ON : 4V~24V
OFF : 0V ~ 3V
4 set Sink mode - Resistance input – Out 5 ~ Out 8.
ON : 200 ohm~ 0 ohm
OFF : 500 ohm ~ ∞
1. The polarity: Right - Positive & Left – Negative .
VER. X.X,
- 7 -