Filter
Top Products
ii
En
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful in-
terference, and (2) this device must accept any interference received, in-
cluding interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to oper-
ate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and op-
erated with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
Nikon Corporation declares that the Wireless Printer Adapter
PD-10 ( FCC ID: MXF-U940829G) is limited in CH1~CH11 for 2.4 GHz
by specified firmware controlled in U.S.A.
Notice for customers in the State of California
WARNING: Handling the cord on this product will expose you to lead, a
chemical known to the State of California to cause birth defects or other
reproductive harm. Wash hands after handling.
Nikon Inc.,
1300 Walt Whitman Road, Melville, New York
11747-3064, U.S.A.
Tel.: 631-547-4200
Notice for customers in Canada
CAUTION
This class B digital apparatus meets all requirements of the Canadian In-
terference Causing Equipment Regulations.
RSS-210 14. Exposure of Humans to RF Fields
The installer of this radio equipment must ensure that the antenna is lo-
cated or pointed such that it does not emit RF field in excess of Health
Canada limits for the general population; consult Safety Code 6, obtain-
able from Health Canada’s website:
www.hc-sc.gc.ca/rpb
ATTENTION
Cet appareil numéique de la classe B respecte toutes les exigences du Rè-
glement sur le matériel brouilleur du Canada.
IC statement
Operation is subject to the following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that
may cause undesired operation of the device.