Nokia 100BASE-T Switch User Manual


 
Product Overview
2 (14) © Nokia Corporation
DN0610789
The information in this document is subject to change without notice and describes only the
product defined in the introduction of this documentation. This document is intended for the
use of Nokia's customers only for the purposes of the agreement under which the document is
submitted, and no part of it may be reproduced or transmitted in any form or means without
the prior written permission of Nokia. The document has been prepared to be used by
professional and properly trained personnel, and the customer assumes full responsibility
when using it. Nokia welcomes customer comments as part of the process of continuous
development and improvement of the documentation.
The information or statements given in this document concerning the suitability, capacity, or
performance of the mentioned hardware or software products cannot be considered binding
but shall be defined in the agreement made between Nokia and the customer. However,
Nokia has made all reasonable efforts to ensure that the instructions contained in the
document are adequate and free of material errors and omissions. Nokia will, if necessary,
explain issues which may not be covered by the document.
Nokia's liability for any errors in the document is limited to the documentary correction of
errors. NOKIA WILL NOT BE RESPONSIBLE IN ANY EVENT FOR ERRORS IN THIS
DOCUMENT OR FOR ANY DAMAGES, INCIDENTAL OR CONSEQUENTIAL (INCLUDING
MONETARY LOSSES), that might arise from the use of this document or the information in it.
This document and the product it describes are considered protected by copyright according
to the applicable laws.
NOKIA logo is a registered trademark of Nokia Corporation.
Other product names mentioned in this document may be trademarks of their respective
companies, and they are mentioned for identification purposes only.
Copyright © Nokia Corporation 2006. All rights reserved.