Filter
Top Products
50 Copyright © 2004 Nokia
AUTOMATIC ANSWER
This profile lets your phone answer incoming calls after just one ring.
1 Place the phone into the car kit holder.
2 Select Menu > Settings > Accessory settings > Handsfree > Automatic
answer > On.
LIGHTS
If you are using your phone with a compatible Nokia car kit, you can set lights to
On (display and keypad lights stay on) or Automatic (after 15 seconds, lights turn
off until the next key is pressed or the phone rings).
1 Place the phone into the car kit holder.
2 Select Menu > Settings > Accessory settings > Handsfree > Lights > On
or Automatic.
Loopset profile
The LPS-3 loopset gives people with T-coil equipped hearing aids the ability to
make and receive calls without noise interference.
Important: Refer to the booklet that comes with the LPS-3 for complete
instructions and safety information.
1 Plug the loopset plug into the jack in the bottom
of the phone, as shown in the illustration.
2 Select Menu > Settings > Accessory
settings > Loopset.
3 Select Use loopset > Yes.
Note: If you want to use the headset or
TTY/TDD, you perform steps 2—3, then select
No to deactivate the loopset profile.
TTY/TDD profile
You can connect your phone to a TTY/TDD device, using the Nokia phone adapter
(HDA-9). In order for your phone to recognize the TTY/TDD, you’ll need to set up the
TTY/TDD profile, under Accessory settings.
Important: Some manufacturers of TTY/TDD devices suggest that the
phone be least at 18 inches from the TTY/TDD device. Remember that when
connecting to any other device, read its user guide or contact its manufacturer
for detailed instructions and safety information.
1 Connect the TTY/TDD device by a cable to the HDA-9 phone adapter.
6010.ENv1_9311233_121903.book Page 50 Tuesday, December 30, 2003 6:16 PM