Filter
Top Products
Managing MW1122
E Copyright Nokia Networks Oy
C33902001SE_00
5-33
The command line interface has been divided into two modes: main
and configuration. The main mode lets you monitor the status and
performance of MW1122. The configuration mode lets you change
MW1122 configuration. The CLI is case sensitive. All commands
must be given in lower case characters. Only file names and strings can
contain upper case characters.
In the configuration mode, functions can be activated by typing the
corresponding command, for example
bridging. The function can be
deactivated by simply typing no bridging. In commands which
require typing in parameter values, the default value can be restored by
typing
de long-retry, for example. de in front of the command
means “default”. If you type in a value which is incorrect (for example,
letters instead of numbers), the CLI prompts you to enter the value
correctly and displays help. You can always get help on the command
or display by typing
help or ? at the command prompt.
You can recall you previous commands by pressing the “up-arrow”
key on your keyboard.
The configuration mode has been divided into levels. You can navigate
through the configuration mode by typing the name of the level. By
typing exit you will return to the main mode. top command returns
you to the root level of the configuration mode (MW1122(conf)#).
The configuration mode levels are:
D system
D password
D eth
D wlan
D vcc1, vcc2, vcc3, vcc4, vcc5, vcc6, vcc7, and vcc8
D vbridge
D mngtvcc
D common.
The example below shows how to access the different levels:
MW1122>
MW1122>conf
MW1122(conf)#system
MW1122(conf-system)#password
MW1122(conf-password)#eth
MW1122(conf-eth)#wlan
MW1122(conf-wlan)#vcc1
MW1122(conf-vcc1)#vcc2