Filter
Top Products
36 Chapter 4 Installing the server and peripheral devices
—End—
What is next?
IF the server is THEN
connected to a Nortel server subnet continue with "Connecting the server
to the Nortel server subnet (optional)"
(page 36).
not connected to a Nortel server subnet continue with installing the software
feature dongle. See "Installing the
Nortel software feature dongle" (page
37).
Connecting the server to the Nortel server subnet (optional)
Introduction
This section provides instructions to connect the server to the Nortel server
subnet.
Note 1: The Nortel server subnet is optional. However, it is required to
support desktop and Web messaging users.
Note 2: If you are installing a High Availability system, do not connect
either sever to the Nortel Server Subnet. The connection to the Nortel
Server Subnet is made when you configure the system.
ATTENTION
To comply with EMC radiation requirements, a Class A Ethernet switch or hub
must be located 10 m (33 ft.) away from the 1005r server. Shielded Ethernet
cables must be used.
To connect the server to the Nortel server subnet
Step Action
1
See the diagram on page "Rear panel connectors" (page 31) to
locate the CLAN connection.
2
Connect an RJ-45 network cable from the Nortel server subnet
Ethernet switch or hub to the CLAN connector.
—End—
Nortel CallPilot
1005r Server Hardware Installation
NN44200-308 01.06 Standard
5.0 15 May 2008
Copyright © 2006-2008, Nortel Networks
.