Filter
Top Products
25
The Uplink/Expansion Module slot on supported switches
accommodates a single MDA using the following connectors.
To install an MDA:
1 Unplug the AC power cord from the back of the switch, or
unplug the switch module from the switch backplane.
2 Loosen the thumb screws and remove the filler panel (or
previously installed MDA) from the Uplink/Expansion
Module slot.
3 Insert the MDA into the Uplink/Expansion Module card
guides (Figure 10).
Make sure the MDA slides in on the card guides. Failure to
align the MDA to the card guides could damage the pins.
Table 12 MDA cable connectors
MDA RJ45 UTP SC fiber MT-RJ fiber
10/100BASE-TX, page 5 X
100BASE-FX, page 9
1000BASE-SX, page 16
1000BASE-LX, page 16
XX
GBIC MDA, page 22 X
Caution: MDAs are not hot-swappable. To avoid
damage to the switch or MDA, power down the switch or
disconnect the switch module from the switch backplane
before installing or removing an MDA.