Filter
Top Products
Inspecting the server interior 29
2
Loosen the three thumbscrews at the rear of the top cover.
3
Remove the server cover by pulling the cover toward the rear of the
chassis, and then lifting it up and off.
4
Clip the lead from your ESD wrist strap to an unpainted metal section
of the chassis.
—End—
What is next?
Continue with "Inspecting the server interior" (page 29).
Inspecting the server interior
Introduction
You should perform a visual inspection for loose components, foreign matter,
or shipping damage inside the server.
CAUTION
When working with interior components, use an ESD wrist strap to
protect static-sensitive components.
To inspect the server interior
Step Action
1 Carefully check all the cards to ensure they are fully seated on the
baseboard.
2
Check for any loose wires or foreign objects, such as loose screws,
inside the chassis.
3 Review the slot locations (see "Slot assignments" (page 15)).
4
Do one of the following:
IF THEN
you observe any damage contact your Nortel technical
support representative.
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300 01.01 Standard
5.0 23 February 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.