Filter
Top Products
Installing the AC power supply 19
CAUTION
Save the power filler panel in case you need to operate
the 8300 Series chassis with a power supply removed.
2
If you are replacing a failed power supply, then remove the failed
supply.
For instructions, see "Removing the AC power supply" (page 20).
3
Grasp the handle of the new power supply.
4 Push the power supply firmly into the bay.
5
Tighten the retaining screws until the power supply is seated firmly.
6
Connect the power cord to the power supply and to an AC power
outlet that is on a circuit with no other equipment connected to it.
Connect each power supply in the chassis to a separate AC circuit.
Nortel Ethernet Routing Switch 8300
Installation — AC Power Supply
NN46200-301 03.01 Standard
4.0 27 August 2007
Copyright © 2007, Nortel Networks
.