Filter
Top Products
72 Chapter 5 Contivity 600 Option Installation
302283-D Rev 00
Installing Contivity 600 option cards
This section shows you how to install LAN or WAN option cards in the Contivity
600.
1
Remove the blank PCI bracket by inserting a Phillips screw driver into the
slot at the right of the blank PCI bracket and rotating the screw
counter-clockwise.
2
Lift out the blank PCI bracket, and slide the replacement card into the
intended slot.
Make sure the card seats firmly and evenly in the card slot and that the left
tabbed-end of the card is seated in its slot. If the card is not seated properly, it
will not work.
3
Replace the screw at the right end of the PCI bracket.
4
Slide the system into the chassis as shown in Figure 33.
Note:
Be careful not to bend the copper fingers in the slot.