Filter
Top Products
Installing and Operating Passport ARN Routers
1-10
114200-E Rev 00
Connecting Communications Cables
Gather the communications equipment and cabling that you will attach to the
ARN. If you do not have the proper cables, contact your network administrator or
see the Cable Guide.
Then, complete the steps in the applicable sections:
•“Connecting to an Ethernet Interface” on page 1-10
•“Connecting to a Token Ring Interface” on page 1-13
•“Connecting to a Serial Interface” on page 1-15
•“Connecting to the ISDN Interface” on page 1-17
•“Connecting to the 56/64K DSU/CSU Interface” on page 1-18
•“Connecting to the FT1/T1 DSU/CSU Interface” on page 1-18
•“Connecting to the E1/FE1 DSU/CSU Interface” on page 1-19
•“Connecting to the X.25 PAD Interface” on page 1-21
Connecting to an Ethernet Interface
You can connect an Ethernet cable to any ARN base or expansion module that
contains an Ethernet interface option.
Note:
For cable interface descriptions, see Appendix C.
Note:
On Ethernet modules that offer two interface types -- an attachment unit
interface (AUI) transceiver interface or a UTP interface -- you can only use one
interface at a time. For example, you can connect to either the AUI transceiver
interface or the 10BASE-T UTP interface on the base module, but you cannot
use both interfaces at the same time.