Filter
Top Products
ENGLISH
NovaJet PRO 600e
Quick Start 17
8 Repeat with each cartridge.
9 Press Utility/Access Cartridges to return the carriage to the service station.
10 Print the color test, prime test pattern and paper axis test as described in
the following sections.
11 If all colors look fine, go on to step 15. If any color drops out, prime car-
tridges as necessary, using the NovaPrime. Place the suction end of the
NovaPrime over the jet area of the cartridge.
12 Make sure the NovaPrime is making good contact with the jet area. Pulse
the pump 3 - 5 times, until the ink is visible in the NovaPrime sight tube.
Maintain good contact between the inkjet plate and the pump for an addi-
tional 5 seconds.
When removing the NovaPrime, use the silicone tip to wipe and clean the jet
plate. Remember to clean the silicone tip of ink before moving to the next
cartridge.
13 Re-print the color test and prime test pattern. (The paper axis test is only
required when changing media). Inspect to ensure proper pressure is
maintained for each color.
14 Re-prime cartridges as necessary to remove clogs. Manually bypass
(compensate) clogged jets as necessary.
15 Once all cartridges are working correctly, print the color deadband and color
calibration test patterns as described in the section on
Aligning the ink
cartridges
which follows.