Filter
Top Products
Rev 100807
8
DIN-Rail Mounting
Install the unit in a standard DIN-Rail. Recess the unit to allow at least 5” of horizontal clearance for fiber
optic cable bend radius (2” for TX models).
To install the unit to 35mm industrial DIN-
Rail, place the top edge of the included mounting
bracket on the back of the unit against the DIN-
Rail at a 15° angle as shown. Rotate the bottom
of the unit to the back (away from you) until it
snaps into place.
To remove the unit from the 35mm industrial
DIN-Rail, place a flat head screwdriver into the
orange release clip found at the bottom of the
unit, and apply downward force on the clip until
it disengages from the bottom of the unit from the
DIN-Rail. Rotate the bottom of the unit towards
you and up at an approximate 15° upward angle
to completely remove the unit.
300-PM 900-PM
900-RM
With the exception of the 524TX
and 526FX2, all N-Tron™ products
are designed to be mounted on
industry standard 35mm DIN-Rail.
However, DIN-Rail mounting may
not be suitable for all applications.
We offer three alternative mounting
solutions: Our 300 Panel Mount
Assembly (P/N: 300-PM) may be
used to mount a single 300 Series unit
to a panel or other flat surface. Our
900 Panel Mount Assembly (P/N:
900-PM) may be used to securely
mount our 100, 200, 300, 400, 500, or
900 Series products to a panel or
other flat surface; Our Rack Mount
Assembly (P/N: 900-RM) may be
used to mount our products to
standard 19" racks.