Filter
Top Products
Introduction to the main system components
Introduction
The following illustration shows the main system components. The table describes the main
components.
1
2
3
4
3
1
2
5
6 6 7
4
[1] The main system components
The main system components
Component Function
1 Operator panel The operator panel helps you with your daily work, for
example the scheduling of the jobs. Furthermore, the
operator panel helps you solve errors or perform main-
tenance tasks.
2 Operator attention
light
The operator attention light enables you to check the
status of the system from a distance.
3 Roll feeder (optional) A roll feeder is an optional device that adds paper input
capacity to your printer. When you use a roll feeder, you
can only use 1 or 2 paper modules. A combination of 3
paper modules and a roll feeder is not possible. The op-
erator panel displays the roll feeder and gives feedback
about the status of the roll feeder. For example whether
the roll is full or empty. Please refer to the documenta-
tion of the roll feeder manufacturer for more informa-
tion, for example about replacing an empty roll.
4 Paper module The paper module contains 4 paper trays. The paper
trays contain the media that will be printed. The default
configuration of the system contains 1 paper module.
You can add 1 or 2 additional paper modules to the de-
fault configuration to increase the media input capacity.
5 Engine module The engine module contains the components that print
the media. Access to the engine module is only required
when a paper jam occurs or when maintenance is re-
quired. The doors at the left-hand side and right-hand
side of the engine module give access to the toner units.
6 PrintGuard modules The PrintGuard modules are required for MICR printing.
The PrintGuard modules postfuse the prints.
4
Introduction to the main system components
10
Chapter 1 - Introduction