Oki 14ex Printer User Manual


 
22 OKIPAGE 14ex, 14i, 14i/n
ttttt
mmm>>
PAPER>>
REQUEST
A request for paper of size mmm.
tttttt = TRAY1, FEEDER, TRAY2 (option).
MEMORY
OVERFLOW
Memory has overflowed for one of the following
reasons.
Too much data on page.
Too much macro data.
Too much DLL data.
Press RECOVER to continue. Install extra memory or
reducedataonpage.
RECBUF
OVERFLOW
The receive buffer memory has overflowed. Press
RECOVER to continue. The PC ignores printer busy
signal in the interface, check cable pin assignments.
PRINT
OVERRUN
Print processing speed could not follow the paper feed
speed. Press RECOVER to continue. Simplify page
formatting data .
HOST I/F
ERROR
Indicates an error in the network or RS232C interface.
Check protocols of printer and host. Press RECOVER to
continue.
TONER
EMP
Indicates that TONER LOW has been exceeded and the
cartridge should be replaced.
tttttt
SIZE ERR
Wrong paper size found. Open and close printer cover
to continue. Check paper size or paper double feed.
tttttt
INPUT JAM
Paper jam found, when fed from paper tray.Check paper
in the tray. Open and close printer cover to continue.
tttttt
FEED JAM
Paper jam found, during paper feed. Remove misfed
paper and close printer cover to continue.
tttttt
EXIT JAM
Paper jam found in paper exit area. Open printer cover,
remove paper, close printer cover to continue.
Message Description
MENU Settings Menu.
COVER
OPEN
Coverisopen.Pressdownfirmlytoclose.
EEPROM
RESETTING
EEPROM ID check error. Press RECOVER to reset
EEPROM to factory default.
ERROR nn
Abnormality found in the printer. Switch printer off then
on again to clear, if problem persists, contact service
representative.
ERROR On
aaaaaaaa
Abnormality found in the controller. Switch printer off
then on again to clear, if problem persists, contact
service representative.
aaaaaaaa = error address
SIMM-ROM
ERROR
Flash SIMM sum check error.
INITIAL-
IZING
Printer is in initialization mode after switching on, prior
to on- line mode.
RESET TO
SAVE
Printer is requesting RESET button to be pressed for
morethan2seconds,towritenewmenudatato
EEPROM.
Message Description