Filter
Top Products
Packet Contents
•
•
•
•
Broadband Wireless Router (AP)
Power Adapter
RJ-45 Ethernet Cable
Quick Started Guide and User Manual CD
Hardware
Front panel
The following illustration shows the front panel of the Broadband Wireless Router (AP):
1. When link is established, the LED is On.
2. When the device is transferring data, the LED is Blinking.
Rear Panel
The following figure illustrates the rear panel of your Broadband Wireless Router (AP).
PWR: Power Switch. -
-
-
-
-
WAN: This RJ-45 10 Base-T port connects to an Ethernet port of xDSL/ATU-R broadband
device.
LAN port L1/L2/L3/L4: 10/100 Base-TX, 4 port auto-sensing & crossover Ethernet switching
hub (LAN interface).
12VDC
: 12V power connector.
RST: Factory default reset switch.
To restore factory defaults, you do not need to power off the device. Push a small, stiff object into
the RST hole to press down the button. Keep pressing and wait fort 3 seconds (the DIAG LED will
illuminate about 3 seconds and turn off) to release the button. The device will automatically restart.
During restart, do not turn on/off the device and wait for the device to boot up.
2