Filter
Top Products
1.1 UNPACKING
Remove the Packing List and verify that all equipment has been received. If there are any
questions about the shipment, use the phone number for the Customer Service Department
nearest you.
Upon receipt of shipment, inspect the container and equipment for any signs of damage. Take
particular note of any evidence of rough handling in transit. Immediately report any damage to
the shipping agent.
The carrier will not honor any claims unless all shipping material is saved for their
examination. After examining and removing contents, save packing material and carton
in the event reshipment is necessary.
1.2 SAFETY CONSIDERATIONS
Refer to your main owners guide manual for complete safety considerations.
This option card is intended for use in a DPF700 panel mount device that is protected in
accordance with Class I of EN 61010 (115/230 AC power connections). Installation of this
instrument should be done by Qualified personnel.
• Do not exceed voltage rating on the label located on the top of the instrument housing.
• Always disconnect power before changing signal and power connections.
• Do not use this instrument on a work bench without its case for safety reasons.
• Do not operate this instrument in flammable or explosive atmospheres.
• Do not expose this instrument to rain or moisture.
• Unit mounting should allow for adequate ventilation to ensure instrument does not
exceed operating temperature rating.
• Use electrical wires with adequate size to handle mechanical strain and power
requirements. Install without exposing bare wire outside the connector to minimize
electrical shock hazards.
1
1
Note
☞
Note
☞