Filter
Top Products
38
English
Appendices
Other Problems
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord and
wait at least 60 seconds before reconnecting power.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. To replace the
lamp, follow the procedures in the “Replacing the Lamp” section on
pages 40-41.
Projector Status Indication
LED lighting message
Message
Power LED Power LED
(Red) (Blue)
Standby State
(Input power cord)
Power on (Warming)
Flashing
(0.5 sec off, 0.5 sec on)
Lamp lighting
Power off (Cooling)
Flashing
(1 sec off, 1 sec on)
<10 sec to off
Error (Over Temp.)
Flashing
(1 sec off, 1 sec on)
Error (Fan fail)
Flashing
(0.5 sec off, 2.0 sec on)
Error (Lamp fail)
Flashing
(0.5 sec off, 0.5 sec on)
Steady light
No light
Downloaded From projector-manual.com Optoma Manuals