Filter
Top Products
14
Installation
Warning Indicator
▀■ When the Lamp LED indicator lights red, the projector will
automatically shut itself down. Please contact your local
reseller or service center. See page 64.
▀■ When the Temp LED is on a steady (not ashing) red, the
projector will automatically shut itself down. Under normal
conditions, the projector can be switched on again after it
has cooled down. If the problem persists, you should contact
your local dealer or our service center. See page 64.
Powering O the Projector
1. Press the " " button on the remote control or " " button on
the panel of the projector to turn o the projector. First push of
button will display the following message on the screen.
Press the button again to conrm the shut down. If the button is not
pressed, the message will disappear in 5 seconds.
2. The Power LED ashes green (1 sec on, 1sec o) and the fans will
speed up during shut down cooling cycle. The projector reaches
stand-by mode as soon as the Power LED ashes green (2 sec on,
2 sec o).
If you wish to turn the projector back on, you must wait until the
projector has completed the cooling cycle and has entered standby
mode. Once in standby mode, simply press " " button on the
rear of the projector or " " on the remote control to restart the
projector.
3. Disconnect the power cord from the electrical outlet and the
projector only when the projector is in stand-by mode.
Note
Note