EN
18
NOTE
The vibrating device is powered by two "AA"
1.5V alkaline batteries (included). It is also compatible
with rechargeable batteries (not included).
THE BACKLIGHT
The user can press the SNOOZE / LIGHT button at the
base of the unit to enable the backlight function and the
backlight will be turned on and last for 5 seconds.
THE RESET HOLE
If the clock behaves strangely or stops responding, insert
and press a blunt stylus into the clock's Reset Hole. (This
is located on the back of the clock. Simply insert a blunt
stylus to reset the unit's settings).
DEFAULT SETTINGS
All segments of the LCD will be turned on for 3 seconds
and a beep sound will be given out. Then it will start RF
reception.
• The Clock Setting are: PM12:00, 1st January,
2004, RF enabled, English.
• The Clock and alarm displays in 24 / 12 hour
mode depending on the selection of radio signal
(EU / UK).
•Both the bell alarm and the vibration alarm of
Alarm 1 and Alarm 2 are disabled.
NOTE
• The battery status is displayed.
• The projector is disabled.
The clock will then be reset to its original factory
setting as seen above.
TROUBLESHOOTING GUIDE
BASIC FUNCTIONS
This section includes a list of frequently asked questions
for problems you may encounter. If your device is not
operating as you think it should, check here before
arranging for servicing.
RM818P English R7 7/14/04, 3:58 PM18