Filter
Top Products
5
EN
GETTING STARTED
BATTERIES
Batteries are not supplied with this product. You will
need to purchase 4 X UM-3 (AA) 1.5V alkaline batteries
for the main unit, and 2 X UM-4
(AAA) 1.5V alkaline
batteries for the remote sensor.
Insert batteries before first use, matching the polarity
as shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
NOTE It is recommended that you use alkaline
batteries with this product for longer performance.
NOTE
Do not use rechargeable batteries.
shows when batteries are low.
UNIT LOCATION
Main Indoor Temperature Area
Remote Outdoor Temperature Area
TABLE STAND OR WALL MOUNT
The table stand is in the back of the product. See below
for how to assemble the table stand.
To mount the product on a wall, put the stand inside
the back of the unit and then place it on a wall, as shown
below.
CHANGE SETTINGS
1. Press and hold MODE for 2 seconds to enter setting
mode.
2. Press
or to change settings.
3. Press MODE to confirm.
1
4
2
3
3
4
2
1
BAR888RA_EN_R15 4/12/05, 9:43 AM5