Filter
Top Products
4 - 34 Trumpcard 14400/28800 Modem
Section Four
The above command processes the &F&C1&D2&S1 once when
the command line is first entered, the S95=18 whenever
operating as a land based connection and S95=44)M1*H2:E0
whenever operating as a cellular based connection.
AT[] or AT[0]
The above command clears any command(s) associated with
event 0 (land based connection).
Modem S Registers
The S registers are summarized below along with their default values.
Registers denoted with an * may be stored in one of the two user profiles
by entering the &Wn command. One of these profiles may be loaded at
any time by using the Zn command.
Default Register Settings
The factory default values are stored in ROM and are loaded into the
active configuration at power up or by the Zn command. In addition, the
designated default profile is subsequently loaded, and may change some
of the factory default values. The designated default profile can be
changed by entering the &Yn command where n is one of the two
possible user profiles. All of the factory default values may be loaded at
any time by entering the &F command.
Modem Register Summary
Register Title Default
S0 * Number of Rings Till Auto-Answer 0
S1 Ring Counter 0
S2 * Escape Character 43
S3 Carriage Return Character 13
S4 Line Feed Character 10
S5 Back Space Character 8
S6 Wait For Blind Dialling * 2
S7 * Wait For Carrier After Dial 50
S8 * Pause Time For Dial Delay 2