Filter
Top Products
9
3. Remove the screw on the side of the hard disk drive bracket holding it to the drive
bracket above (see Fig 6 in section Removing the Drive Bracket).
4. Slide the hard disk drive bracket backwards out of the chassis.
Fig. 12: Removing the hard disk drive bracket
5. Remove the screws that hold the hard disk drive in the bracket and slide it out.
Removing Add-In Cards
To remove add-in cards, first remove the rear bezel (see section Removing the Rear Bezel)
and remove the left side cover (see section Removing the Left Side Cover); then follow the
steps below:
1. Disconnect all cables from the add-in card to be removed.
2. Press the two metal clips until the retention bracket unlocks and remove the
bracket.
Fig. 13: Remove the retention bracket
3. Carefully take out the card from the slot.
Removing the Front USB Port
To remove the front USB port, first remove the rear bezel (see section Removing the Rear
Bezel) and remove the left side cover (see section Removing the Left Side Cover), remove
the front bezel (see section Removing the Front Bezel); then follow the steps below:
1. Disconnect the USB port cable on the motherboard and/or on the USB port itself.
2. Remove the screws holding the USB port to the chassis.
Packard Bell Stella (iXtreme) Disassembly Manual