Filter
Top Products
14
Connections
Connection procedure
2(:): Up
8(;): Down
4(!): Left
6(#): Right
1 (TELE): Zoom in
7 (WIDE): Zoom out
3 (FAR): Focus (long-distance)
9 (NEAR): Focus (close-up)
5 (BAR): Color bar output
0 (CAM): Camera thru output
3 Select the pan-tilt head system to be controlled.
Press the key ( i ) to change
the menu setting item.
When “Menu-6 Output-2” appears on the LCD panel,
use the ! # keys and select
P1, P2, P3, P4 or P5.
STOPSTART
START
2
MENU+
When the settings are completed, press the
key ( i ) once again to exit the menu
settings.
START
2
MENU+
START
1
M1
2
M2
0
DEL
CAM
5
M5
TELE
3
M3
FAR
78
WIDE
9
NEAR
4
M4
MENU
CLEAR
STOP
MENU
RECALL
6
BAR
4.
When the settings are completed, turn the power of the
AW-DU600 off and then back on again.
The power of the pan-tilt-head system turns on and
operation is possible.
5.
The pan-tilt head system can be controlled in the
following ways using the operating keys on this adapter.
Menuj 6 Output-2
P1 P2 P3 P4 P5
2 Set the CONTROL OUT connector according to the
type of pan-tilt connected and the connection
distance.
Press the key ( i ) to change
the menu setting item.
When “Menu-5 Output-1” appears on the LCD panel,
use the ! # keys and select
RS-2332C or RS-422 according to the pan-tilt head
system to be connected.
STOPSTART
START
2
MENU+
1.
Connect the pan-tilt head system to the CONTROL
OUT connector on this adapter.
2.
Turn on the power to this adapter and the pan-tilt head
system.
3.
Dial Up Adapter settings
1 Set this adapter to direct mode.
Press the key ( i ) to open
the menu settings.
When “Menu-1 Function” appears on the LCD panel,
use the ! # keys and select
Direct (direct mode).
STOPSTART
START
2
MENU+
Menuj 1 Function
Tx Rx Direct
Menuj 5 Output-1
RSj 232C RSj 422