Filter
Top Products
11
Connections
Menuj 1 Function
Tx Rx Direct
Menuj 5 Outputj 1
RSj 232C RSj 422
When the settings are completed, press the
key ( i ) once again to exit the menu
settings.
START
2
MENU+
Receiving system connection procedure
1.
Connect the AW-PS301 AC adapter to the DC 12V IN
connector on this adapter.
3.
Connect the telephone line to the line input jack on the
modem.
5.
Set the power switch on the AW-DU600 to ON.
7.
Set the power switch on the modem and the pan-tilt
head to ON.
8.
“OK” appears on the LCD panel.
6.
Dial Up Adapter settings
1 Set this adapter to receive mode.
Press the key ( i ) to open
the menu settings.
When “Menu-1 Function” appears on the LCD panel,
use the ! # keys and select
Rx (receive mode).
STOPSTART
START
2
MENU+
2 Select the pan-tilt head system control.
Press the key ( i ) to change
the menu setting item.
When “Menu-5 Output-1” appears on the LCD panel,
use the ! # keys and select
RS-2332C or RS-422 according to operating
conditions.
STOPSTART
START
2
MENU+
4.
Connect the pan-tilt head to this adapter.
O If the connection distance between this adapter and
the AW-PH300A pan-tilt-head is 10 m or less, use
the AW-CA28T9 (10 m) cable to connect the RS-
232C CONTROL OUT connector on this adapter to
the P/T CONTROL IN connector on the AW-PH300A.
O If the connection distance between this adapter and
the AW-PH300A pan-tilt-head is more than 10 m, use
an RS-232C/RS-422 converter between the RS-422
CONTROL OUT connector on this adapter to the P/T
CONTROL IN connector on the AW-PH300A when
performing the connection.
O When the AW-PH350 pan-tilt-head is used, use a 10
BASE-T cable to connect the RS-422 CONTROL
OUT connector on this adapter to the CONTROL IN
IP/RP connector on the AW-PH350.
When an AW-RP301 or AW-RP501 is used as the
controller, connect the pan-tilt head to the P1
CONTROL OUT connector on this adapter.
2.
Connect the TO MODEM connector to the RS-232C
connector on the modem using the RS-232C cable
provided with the modem.
Mode : Receiver
OK
Mode : Receiver
jj jj jj
If the modem is not connected correctly, [---] will appear
on the LCD panel.