Panasonic BT-H1700P Computer Monitor User Manual


 
Compliant Signal Formats of Each Input Card
Input Signals BT-YA701P BT-YA702P BT-YA703P BT-YA704P
NTSC (3.58 MHz) R ——
PAL (4.43 MHz) R ——
Black-and-White (50 Hz/60 Hz) R —— —
480/60i (525i) RR
480/60p (525p) R ——
576/50i RR
576/50p (*1) ——
720/60p (720p) R R
1080/50i (*1)
1080/60i (1125i) (*2) R R
1035/60i (1125i) (*1 *3)
1080/24psF (*4) R R
R : Input possible. Pre-set.
: Input possible. Not pre-set. Any adjustments required in some cases.
: Input impossible
*1 : 1080/50i, 1035/60i and 576/50p are not pre-set. When these signals are input, some adjustments are required.
*2 : Including 1080/59.94i.
*3 : Including 1035/59.94i.
*4 : Including 1080/23.98psF.
Usage Precautions
The selected signal is output from the SWITCHED OUT terminal only when the monitors power is turned on.
The output signal from the SWITCHED OUT terminal is the one that is selected from the signals input to SDI 1 / HD SDI 1 or
SDI 2 / HD SDI 2.
The table below shows the connection between the INPUT SELECT buttons (input signal selection) and the input/output of
the SDI / HD SDI input card.
Selected INPUT SELECT Buttons Signal Output from the SWITCHED OUT Terminal
A, C, E Signal from SDI 1 / HD SDI 1
B, D, F Signal from SDI 2 / HD SDI 2
This section explains the usage precautions and connection examples when using the SWITCHED OUT terminal of the SDI / HD
SDI input card.
APPENDIX: CONNECTION EXAMPLES FOR THE
SDI / HD SDI INPUT CARD
22