Filter
Top Products
– 17 –
Setup
Initial Preparation
Installing the recording paper
Note:
●
Only use the included roll of paper or specified recording paper, or else the print quality may be affected
and/or excessive thermal head wear may occur.
●
To order recording paper, see page 5.
●
When the power cord is connected, everytime you close the cover a message will be printed. If the recording
paper is set to the wrong side, a message will not be printed. Install the paper correctly.
1
Open the cover by pressing the cover open
button and
install the recording paper roll.
●
If the paper is secured with glue or tape, cut
approximately 15 cm (6 inches) from the
beginning of the roll.
2
Insert the leading edge of the paper into the
opening above the thermal head and pull it out of
the unit.
●
Make sure that there is no slack in the paper
roll.
3
Close the cover securely by pushing down on
both corners.
Cover open
button
Thermal head
correct
incorrect
Installing the paper stacker
Install the paper stacker.
Paper stacker