Panasonic KX-HNB600 Switch User Manual


 
Part names and functions
C
B
A
D E
G H I
F
Speaker
LED indicator
DC jack
LINE jack
MWi-Fi SETUPN
Used when performing initial setup.
microSD card slot
Used when inserting a microSD card.
Remove the label when inserting.
M HANDSET/LOCATORN
Used when registering a handset. You
can also press this button to locate a
misplaced handset.
M CAMERAN
Used when registering a camera.
M OTHER DEVICEN
Used when registering a sensor or smart
plug.
LED indicator
You can use the LED indicator to confirm the
hub’s status.
Indicator Status
Off No power, or LED
indicator is turned
off
*1
Indicator Status
Green, lit Normal operation,
connected to
wireless router
*1
Green, blinking Registration mode
Alternating:
Green, blinking
Yellow, blinking
Hub is starting up
(cannot be used
yet)
*2
Red, lit Security system is
armed
Red, blinking quickly Security system was
triggered
Yellow, lit Initial setup required
Yellow, blinking Initial setup in
progress, mobile
device connected
Yellow, blinking
quickly
Initial setup is
starting
*1 You can configure the hub so that its LED
indicator does not light during normal
operation. For more information, refer to
the User’s Guide (page 15).
*2 It may take some time for the hub to finish
starting up.
Connections
Insert the AC adaptor plug firmly into the
DC jack.
Secure the AC adaptor cord by wrapping
it around the hook.
Connect the AC adaptor to the power
outlet.
Insert the telephone line cord into the
LINE jack and a single-line telephone jack
(RJ11C) until you hear a click.
DSL/ADSL service users only: Connect
your DSL/ADSL filter (not supplied).
Outdoor Camera (KX-HNC600) or
Indoor Camera (KX-HNC200) users
only: Remove the label covering the card
slot and then insert the microSD card (not
supplied) into the slot with the notched
corner (
1
) facing upwards (
2
) until it
clicks into place.
10
For assistance, please visit www.panasonic.com/support
Setup