Panasonic KX-MB2030CX All in One Printer User Manual


 
For your safety
Laser radiation
CLASS 1 LASER PRODUCT
The printer of this unit utilises a laser. Use
of controls or adjustments or performance
of procedures other than those specified
herein may result in hazardous radiation
exposure.
Laser diode properties
Laser output : Max. 15 mW
Wavelength : 760 nm – 800 nm
Emission duration : Continuous
LED light
CLASS 1 LED PRODUCT
Do not view directly with optical
instruments.
LED light of CIS properties
LED radiation output : Max. 1 mW
Wavelength :
Red 630 nm typ.
Green 520 nm typ.
Blue 465 nm typ.
Emission duration : Continuous
Fuser unit
During or immediately after printing, the
fuser unit (A) gets hot. This is normal. Do
not touch the fuser unit.
Note:
R The area near the output tray (B) may also get warm.
This is normal.
B
A
For best performance
Toner cartridge and drum cartridge
R When replacing the toner cartridge or drum cartridge,
do not allow dust, water, or liquids to come in contact
with the drum. This may affect print quality.
R For optimal performance, genuine Panasonic toner
cartridges and drum cartridges are recommended.
We cannot be responsible for problems that may be
caused by a non-Panasonic toner cartridge or drum
cartridge:
Damage to the unit
Poor print quality
Improper operation
Toner cartridge
R Do not leave the toner cartridge out of the protective
bag for a long time. It will decrease the toner life.
Drum cartridge
R Read the instructions on page 11 before you begin
installation of the drum cartridge. After you have read
them, open the drum cartridge protective bag. The
drum cartridge contains a photosensitive drum.
Exposing it to light may damage the drum. Once you
have opened the protective bag:
Do not expose the drum cartridge to light for more
than 5 minutes.
Do not touch or scratch the black drum surface.
Do not place the drum cartridge near dust or dirt,
or in a high humidity area.
Do not expose the drum cartridge to direct
sunlight.
R To extend the life of the drum cartridge, the power
switch should never be turned OFF immediately after
4
Important Information