Filter
Top Products
(TALK) and
Indicator
(CH)
(LOUD)
(REDIAL)
To redial the last number dialled
Press (TALK) (REDIAL).
To select the handset receiver
volume
Press (LOUD) while talking.
≥Each time you press the button, the
volume level will change from LOW
(preset) to HIGH.
If noise interferes with the
conversation
Press (CH) to select a clearer channel or
move closer to the base unit.
Backlit handset keypad
The handset dialling buttons will light when
you press a button or lift the handset off the
base unit, or when a call is received. The
lights will go out a few seconds after
pressing a button, lifting the handset or
answering a call.
1
Press (TALK).
≥The TALK indicator lights.
≥If an alarm tone sounds, see 6-E.
2
Dial a phone number.
3
To hang up,
press (TALK) or place the
handset on the base unit.
≥The indicator light goes out.
≥For best operating performance, see
section 6-C.
≥When dialling additional numbers after
speed dialling [eg, AUTO (3-B), DIRECT
(4-B) or REDIAL], make sure that speed
dialling is finished before entering
additional digits.
Otherwise, the unit may not dial correctly.
Selecting the ringer volume
The TALK indicator light must be off.
≥To select HIGH (preset) or LOW,
press (RINGER).
Each time you press the button, the
ringer volume will change and the
selected volume will ring.
≥To turn the ringer OFF,
press and hold (RINGER) until a beep
sounds.
≥To turn the ringer ON,
press (RINGER).
If the handset is off the base unit,
press (TALK).
≥You can also answer a call by pressing
any dialling button (0) to (9),
($)
or
(—Any Key Talk).
OR
If on the base unit,
just lift up.
(TALK) and Indicator
(RINGER)
2-A Making Calls
2-B Answering Calls
2
Making/Answering Calls
Section 2
For New Zealand Users Only:Additional Security Feature
In the event that a call cannot be made from the handset following a power interruption,
disconnect the base unit from the line momentarily then reconnect it. Turn the handset off, and
replace it on the base unit.
This will re-establish the security system and the handset can be used as before.