Panasonic KX-TC1200NZB Tablet User Manual


 
6-A Battery
Recharge
When the RECHARGE indicator flashes
or the unit beeps intermittently, place
the handset on the base unit for about
15 hours to recharge the battery.
6-B Battery Replacement
If the RECHARGE indicator flashes after being fully charged, replace the
battery with a new Panasonic P-P301 (KX-A36A) battery.
When replacing the battery, programmed information may be erased.
Reprogram if necessary.
Battery information:
After your Panasonic battery is fully charged:
While in use (TALK)
While not in use (Standby)
Up to about 5 hours
Up to about 14 days
RECHARGE
Indicator
The battery operating time may vary depending on usage
conditions and ambient temperature.
As preventative maintenance, clean the handset and the
base unit charge contacts with a soft, dry cloth once a
month. Clean more often if the unit is subject to grease, dust
or humidity. Otherwise the battery may not charge properly.
If the battery is fully charged, you do not have to place the
handset on the base unit until the RECHARGE indicator flashes.
This will maximize the battery life.
The battery cannot be overcharged.
1
Press the notch on the
handset cover firmly
and slide it as
indicated by the
arrow.
2
Replace the battery
and close the cover.
Insert the battery plug into
the connector as shown in
the picture.
Be sure wires are free from
being pressed by the battery
body or the handset cover.
3
Make sure to charge
the new battery for
about 15 hours.
Operation
Operating time
6-C Base Unit Location
Calls are transmitted between the base unit and the handset
using wireless radio waves. For maximum distance and noise-
free operation, the recommended base unit location is:
6-D Wall Mounting
This unit can be mounted on a wall.
In a HIGH and CENTRAL
location with no obstructions
such as walls.
Extend
fully.
Away from electrical appliances
such as a TV, personal computer,
cellular phone charging units
or another cordless phone.
To Power
Outlet
8.3 cm
Screws
For Australia
To Telephone Plug
and Socket
OR
For New Zealand
To Single-Line
Telephone Jack
1
Pull down the handset
hook until it locks, so
the tab holds the
handset.
2
Install screws using
the wall template
below. Connect the AC
adaptor and telephone
line cord.
3
Mount the unit, then
slide down.
Extend the antenna fully.
8.3 cm
Wall Template
Red
Lead
Black
Lead
6
Things You Should Know
Things