Filter
Top Products
E
NGLISH-27
Basic operation
Select the input signal by pressing the INPUT
SELECT button or the DIRECT INPUT SELECT
buttons.
BA picture will be projected in accordance with the selected input
signal. (page 30)
BWhen “SIGNAL SEARCH” is set to “ON”, the projector detects
which signals are being input, and uses these signals for
projection.
BIf no signal is detected, the guide screen for computer connection
will be displayed (when “INPUT GUIDE” in the “OPTION” menu is
set to “DETAILED”. Refer to page 69 for details).
BPress the INPUT SELECT button to finish the input signal search.
Follow the procedure below when you set the projector up first, and when
you change the placement after original setup.
Press the AUTO SETUP button (when RGB
signals are being input).
BSettings such as the position of the
image will be corrected automatically.
(page 31)
Adjusting the size
BTurn the zoom ring to adjust the size of the projected image.
Adjusting the focus
BTurn the focus ring to adjust the focus of the projected image.
&
'
)
*
(
Adjusting the angle
BPlace the projector so that it is
vertical to the screen.
BWhile pressing the adjuster buttons,
adjust the forward/back angle of tilt of the
projector. Adjust so that the projected
image is placed at the center of the
screen.
Direct power on function
If “DIRECT POWER ON” in the “OPTION” menu is set to “ON”, projection
will start after the power cord is connected. Refer to page 51 for details.