Panasonic PT-LB60U Projector User Manual


 
52-E
NGLISH
RGB/YP
BPR
(480i, 576i, 480p, 576p, 1 080/60i,
1 080/50i, 720/60p and VGA480
signals only)
This sets the signal that is input to
the PC 1 IN and PC 2 IN/PC 1 OUT
connector.
Normally “AUTO” should be
selected. RGB or YPB
PR is selected
automatically depending on the
synchronising signal status.
If an image is not projected
correctly, select “RGB” or “YP
BPR
in accordance with the input signal.
VOLUME
You can adjust the volume of the
sound that is output from the
projector’s built-in speaker and
VARIABLE AUDIO OUT connector.
INSTALLATION
This setting should be changed in
accordance with the projector
setting-up method. (Refer to page
18.)
FRONT/DESK
When the projector is placed on a
desk or similar in front of a screen.
FRONT/CEILING
When the projector is placed in front
of a screen and suspended from a
ceiling using a ceiling bracket (sold
separately).
REAR/DESK
When using a translucent screen
and the projector is placed on a
desk or similar.
REAR/CEILING
When using a translucent screen
and the projector is suspended from
a ceiling using a ceiling bracket
(sold separately).
HIGHLAND
Set “HIGHLAND” to “ON”, when
using this projector at high
elevations (above 1 400 m) only.