Filter
Top Products
34 - ENGLISH
Settings
POSITION Menu
You can move the projected image horizontally for fine
adjustment.
You can move the projected image vertically for fine
adjustment.
If you have interference patterns on the projected
image, which is sometimes referred to as moire or
noise, you can minimize it by pressing I H to adjust the
clock frequency.
If you require further adjustment for the same reason as
the DOT CLOCK adjustment, you can fine adjust the
timing of the clock. Press I H to adjust.
H - POSITION
V - POSITION
See “Navigating through
the MENU” on page 28.
Move
right
Move
left
Move
up
Move
down
DOT CLOCK
NOTE:
If the projecting signal’s dot clock frequency is
higher than 150 MHz, the adjustment may not
make a difference.
CLOCK PHASE
NOTE:
If the projecting signal’s dot clock frequency is
higher than 150 MHz, the adjustment may not
make a difference.
CLOCK PHASE is available with PC signals, and
1 125 (1 080)/50i, 1 125 (1 080)/60i,
1 125 (1 080)/50p, 1 125 (1 080)/60p,
1 125 (1 080)/24p, 750 (720)/50p and
750 (720)/60p signals of COMPONENT
connection.
PT-AE1000U.book Page 34 Monday, October 16, 2006 1:40 PM