Filter
Top Products
ENGLISH-31
Basic Operation
30-ENGLISH
Setting the ASPECT
This projector allows you to change the aspect ratio to match the type of
input signal. Pressing the ASPECT button will change the aspect ratio
according to the successive settings shown below.
(You can also change the aspect ratio by selecting the POSITION item in the
MAIN MENU and pressing ENTER.)
Illustrations for aspect ratio settings are shown on the next page. Refer to
this illustration for assistance in selecting a suitable aspect ratio.
About S2 and S1 video signals:
BS2 and S1 video signals are for 16:9 images and include a notification
signal when being played by devices such as a DVD player.
BWhen the projector is set to the “S1/S2” setting shown above, it will detect
those notification signals and automatically switch to the correct aspect
ratio for projection.
NOTE:
BThis projector is equipped with an aspect ratio selection function.
However, if a mode which does not match the aspect ratio of the input
signal is selected, it may affect the quality of viewing of the original picture.
Keep this in mind when selecting the aspect ratio.
BIf using this projector in places such as cafes or hotels with the aim of
displaying programmes for viewing for a commercial purpose or for public
presentation, note that if the aspect ratio (16:9) selection function is used
to change the aspect ratio of the screen picture, you may be infringing the
rights of the original copyright owner for that programme under copyright
protection laws.
BIf a normal (4:3) picture which was not originally intended for wide-screen
viewing is projected onto a wide screen, distortion may occur around the
edges of the picture so that part of the picture is no longer visible. Such
programmes should be viewed in 4:3 mode to give proper consideration to
the aims and intentions of the original programme’s creator.
BThe following signals have resolutions that are 16:9 image sizes. The
aspect ratios for these signals cannot be changed while being played
because they are already established. (Refer to page 49.)
HDTV60, HDTV50, 750p, WIDE 400/480/600/720/768
BImage sizes such as Cinema-Vision that project wider than the 16:9 ratio
will have narrow black fields at the top and bottom.
S-VIDEO S1/S2\4:3\16:9\JUST\ZOOM
VIDEO/YP
BPR
4:3\16:9\JUST\ZOOM
PC 4:3\16:9\V SCROLL
4:3 4:3 Input signal 4:3
16:9 Squeezed signal (image
contracted horizontally)
Horizontal expansion of
projected image
JUST 4:3 Input signal
Horizontal expansion of projected image
(Centre of image is less distorted)
ZOOM Letterbox signal Expansion preserves
original ratio
V SCROLL 4:3 Input signal
Enlarges image approximately
1.2 times (Vertical position can
be adjusted by the G and F
buttons)
ASPECT Input signal Projected Image