Filter
Top Products
Settings
PROJECTOR SETUP menu
ENGLISH - 30
You can see the status of the projector about the following
items.
After you replaced the Auto Cleaning Filter (ACF),
REMAINING FILTER of STATUS need to be reset to "0".
1. Press the ENTER button.
2. Select OK by pressing I, then press the ENTER button.
3. The REMAINING FILTER of STATUS will be reset to
“0”.
Display the STATUS and confirm the figure.
You can set the timer to switch off the power of the projector
after a certain period of time automatically when no signal is
detected. Press I H to select the required period from 10 to
90 minutes at intervals of 10 minutes.
You can assign a certain menu function to the FUNCTION
button as shortcut. Press I H to select the required menu
option, and the ENTER button.
STATUS
Items Description
INPUT Displays the input selection state.
NAME Displays the input signal name.
SIGNAL FREQUENCY
Displays the frequency of the input
signal.
PROJECTOR RUNTIME Displays the projector runtime.
LAMP1 Displays the lighting time of LAMP1.
LAMP2 Displays the lighting time of LAMP2.
INTAKE AIR TEMP.
Displays the intake air temperature of
the projector.
OPTICS MODULE TEMP.
Displays the temperature inside the
projector.
AROUND LAMP TEMP.
Displays the temperature around the
lamp of the projector.
REMAINING FILTER Displays the filter runtime.
QUANTITY Displays the filter remaining quantity.
PROJECTOR TYPE Displays type of projector.
SERIAL NUMBER
Displays the serial number of the
projector.
MAIN VERSION
Displays the main version of the
firmware of the projector unit.
SUB VERSION
Displays the sub version of the
firmware of the projector unit.
NETWORK VERSION
Displays the network version of the
projector unit.
ON COUNT
POWER ON TIMES
Displays the number of times the
power has been tuned on.
LAMP1 ON
Displays the number of times LAMP1
has been lit.
LAMP2 ON
Displays the number of times LAMP2
has been lit.
SHUTTER
Displays the number of times the
shutter function has been used.
LAMP1 LOW
Displays the LAMP1 lighting time with
LOW setting in LAMP POWER.
HIGH
Displays the LAMP1 lighting time with
HIGH setting in LAMP POWER.
LAMP2 LOW
Displays the LAMP2 lighting time with
LOW setting in LAMP POWER.
HIGH
Displays the LAMP2 lighting time with
HIGH setting in LAMP POWER.
NUMBER OF ENTRY
SIGNAL
Displays the number of registered
signals.
REMOTE2 STATUS Displays REMOTE 2 IN
control status.
FILTER COUNTER RESET
NOTE:
• See “Replacing the Auto Cleaning Filter (ACF)” in the
operating instructions booklet that is provided with the
projector.
NO SIGNAL SHUT-OFF
DISABLE
FG FG
10 MIN.
90 MIN.
FG FG
20 MIN.
80 MIN.
FG FG
30 MIN.
70 MIN.
FG FG
40 MIN. 60 MIN.
FG FG
50 MIN.
FUNCTION BUTTON
Options Functions Refer
DISABLE
Deactivate the FUNCTION
button.
-
SUB MEMORY LIST
Displays the assigned SUB
MEMORY LIST.
34
SYSTEM SELECTOR
Switches SYSTEM SELECTOR
options.
17
SYSTEM DAYLIGHT
VIEW
Switches the SYSTEM
DAYLIGHT VIEW setting.
17
FREEZE Freezes the image. 27
SIDE BY SIDE Start the SIDE BY SIDE mode. 27