Panasonic PT-D6000E Projector User Manual


 
Preparation
About Your Projector
ENGLISH - 15
Setting projector ID number to
remote control
Each projector can be assigned a unique 2 digits ID
number, and the remote control 2 digits ID number must
be set to match the intended projector. The default
setting of the projector ID is ALL. Set the ID of the
projector in advance from the menu items.
1.Press the ID SET button.
Displays the projector ID number on the screen.
2.Within 5 seconds, enter the same number of the required
projector by pressing the numeric buttons.
ID number range: 01 - 64
Using a wired remote control
When multiple projectors are connected as part of the
system, connect to units with a M3 stereo mini jack
commercial cable to simultaneously control multiple main
units with a single remote control through the REMOTE 1
IN/OUT terminal. It is effective to use the wired remote
control in the environment in which an obstacle stands in
the light path or where devices are susceptible to outside
light.
NOTE:
Do not press the ID SET button accidentally or carelessly
because the ID number on the remote control can be set even
when no projector is around.
If you do not enter the 2 digits ID number within 5 seconds
after the ID SET button has been pressed, the ID will remain at
the number that was set before the ID SET button was
pressed.
Your specified ID will be erased if the batteries of the remote
control are left exhausted. When the batteries are replaced,
set the same ID number again.
NOTE:
Use 2 core shielded cable of length of 15 m or less. If the
length of the cable exceeds 15 m (49'2"), the shielding of the
cable may not be sufficient and the remote control may not
work.
Connect to another
projector
M3 stereo mini jack
(commercial)
Connect to the remote
control wired terminal