Panasonic PT-DW730E Projector Accessories User Manual


 
About Your Projector
ENGLISH - 17
Preparation
About Your Projector
Remote control
Top
(1) Remote control indicator
Flashes by pressing any buttons.
(2)
STANDBY (
) button
Sets the projector to the standby mode when the <MAIN POWER> switch on the
projector is set to <ON>.
(3)
POWER ON (
) button
Starts projection when the <MAIN POWER> switch on the projector is set to <ON>
and in the standby mode.
(4)
Input Selection (<RGB1>, <RGB2>, <DVI-D>, <VIDEO>, and <S-VIDEO>) buttons
Switches the input signal to project. (
page 38)
(5) <MENU> button/<ENTER> button/ ▲▼◀▶ buttons
Use it to operate the menu screen. (
page 41)
(6) <ON SCREEN> button
Switches on (display)/off (not display) the on-screen display function. (
page 38)
(7) <TEST PATTERN> button
Displays the test pattern. (
page 39)
(8) Number (<0> - <9>) buttons
Use it when the system uses multiple projectors.
Used to input the ID numbers or passwords.
(9) <STATUS> button
Displays the information of the projector.
(10) <AUTO SETUP> button
Automatically adjusts the image display position while projecting the image.
[PROGRESS] is displayed o
n the screen while the image is adjusted automatically.
(
page 39)
(11) <SHUTTER> button
Use it to temporarily turn off the image. (
page 38)
(12) <ASPECT> button
Switches the aspect ratio of the image. (
page 40)
(13) Lens (<FOCUS>, <ZOOM>, and <SHIFT>) buttons
Adjusts the projection lens. (
pages 34, 36)
(14) <FUNCTION> button
You can assign a frequently used operation and use as a shortcut button. (
page 39)
(15) <DEFAULT> button
Restores the contents of the sub-menu to the factory default setting. (
page 41)
(16) <ID SET> button
Sets the ID number of the remote control when the system uses multiple projectors.
(
page 20)
(17) <ID ALL> button
Simultaneously controls all the projectors with one remote control when the system
uses multiple projectors. (
page 20)
Attention
z
Do not drop the remote control.
z
Av
oid contact with liquids or moisture.
z
Do not attempt to modify or disassemble the remote control.
Note
z
The <SDI> button cannot be used.
z
The remote control can be used within a distance of about 30 m if pointed
directly at the remote control receiver. The remote control can control
at angles of up to
±
15
°
vertically and
±
30
°
horizontally, but the effective
control range may be reduced.
z
If there are any obstacles between the remote control and the remote
c
ontrol signal receptor, the remote control may not operate properly. The
signal will be reected off the screen, but the operating range may differ
due to the screen material.
z
If the remote control signal receptor receives strong light such as
uorescent light directly, the remote control may not operate properly. Use
it in a place distant from the light source.
Remote control signal emitters
Front
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
Bottom
Remote control wired terminal
(
page 20)