Filter
Top Products
Setting
ENGLISH -
67
Settings
Simple mode
This function decides whether to activate the simple
mode.
Press ▲▼ to select [Simple mode] and 1 )
then press the <ENTER> button.
Press ▲▼ to switch between [On] and 2 )
[Off].
On
Simple mode function is off.
Off
Only the simple mode buttons
are active.
Note
Warning icon and
z
[Simple mode : On] message
appear on the screen for about 4 seconds when
press the button which is not the simple mode
button.
Remote control
This switching function prevents remote control
interference when operating several projectors or
video equipment at the same time.
Press ▲▼ to select [Remote control].1 )
Press the <ENTER> button.2 )
Press ▲▼ to select one among the 3 )
sixty and ve codes.
This projector provides 65 different remote
z
control codes: [All], [Code 01]~[Code 64].
Note
When operating the projector under [All] code, you can
z
operate several projectors at the same time. If you want
to operate the projector independently, you must switch
to other code.
When different codes are set on the projector and on the
z
remote control, any operation cannot be made. In that
case, switch the code on the remote control to t the
code on the projector.
RC sensor
Select a location of the infrared remote receiver of the
remote control.
Press ▲▼ to select [RC sensor].1 )
Press ► or the <ENTER> button.2 )
Press ▲▼ to select one among 3 )
options as below.
All
Activate all of the receivers.
Front &
Top
Activate both the front and top
receivers.
Top &
Back
Activate both the top and back
receivers.
Front &
Back
Activate both the front and back
receivers.
Front
Activate only the front receiver.
Top
Activate only the top receiver.
Back
Activate only the back receiver.
Eco management
Can optimize lamp power and reduce the power
consumption according to the application.
Press ▲▼ to select [Eco 1 )
management].
Press ► or the <ENTER> button.2 )
Auto power save
J
Press ▲▼ to select [Auto power save] 1 )
and press the <ENTER>button.
Press ▲▼ to choose [On] between 2 )
[On] and [Off].
Press ▲▼ to select auto power save 3 )
conditions.
Ambient light
detection
Adjusts the lamp power according
to the ambient brightness.
Signal
detection
Drops the lamp power when no
signal is input.
AV mute
detection
*
1
Drops the lamp power in the AV
mute mode.
This function is only for EW530 series and *1 :
EX500 series.
Note
When [Auto power save] is [Off], [Ambient light
z
detection], [Signal detection] and [AV mute detection] are
not available.
Only these buttons are active
when the simple mode is set to
[On]. [POWER ON, STANDBY,
SHUTTER (AV MUTE), INPUT,
MENU, AUTO PC ADJ, ▲, ▼
(MUTE), ◄ (VOLUME-), ►
(VOLUME+), ENTER, IMAGE
SELECT, IMAGE ADJUST,
P-TIMER, ECO, SCREEN, P IN
P, ON /OFF]. Number buttons
also become active only when
setting the remote control codes
numbers or entering the PIN
code numbers.